Mylex PCI Disk Array Controller Drivers 08P4100, Installation And User Manual

Page: 39 / 100

Windows 2000
Manual No. 775079 4-3
4
W
I
N
2
0
0
0
Installing the Mylex Disk Array Controller as the
Primary Windows 2000 Controller
Before proceeding you should have already carried out the following steps:
• Installed the Mylex Disk Array Controller hardware, connected the
disk drives to the controller and to each other, set the drive SCSI IDs,
and terminated the SCSI bus following the instructions in your Mylex
Disk Array Controller hardware installation guide.
• Used the RAID EzAssist Configuration Utility to create a drive
configuration and initialized the drives for use following the
instructions in your Mylex Disk Array Controller Configuration Utility
manual.
Use the following table to determine the installation procedure to use.
Table 4-1. Installation Procedure to Use for Each Controller
RAID Controller Model Installation Procedure No. Page No.
eXtremeRAID 2000 Installation Procedure 1 page 4-4
eXtremeRAID 3000 Installation Procedure 1 page 4-4
AcceleRAID 160/170LP Installation Procedure 1 page 4-4
AcceleRAID 170 Installation Procedure 1 page 4-4
AcceleRAID 352 Installation Procedure 1 page 4-4
DAC960P Series Installation Procedure 2 page 4-13
AcceleRAID 150 Installation Procedure 2 page 4-13
AcceleRAID 200 Installation Procedure 2 page 4-13
AcceleRAID 250 Installation Procedure 2 page 4-13
eXtremeRAID 1100
(DAC1164P) Installation Procedure 2 page 4-13