Mylex
and Operation Guide
if the board is upgraded for 128K of Cache, see
section xxx.
Jumper JP3 is a factory jumper for “Pipe-Line-Mode” on the
CPU and should not be altered.
Chassis Installation
Use caution when sliding the MT1386 into the chassis so as not
to scrape the bottom of the board against any rough edges.
Use as many plastic stand-offs as possible to better support
the board. Use a minimum of two screws (preferably in oppos-
ing corners) to lock the board in place.
Figure l-5: Control Panel Connections
Cables
Connect the power cables from the power supply to the system
board. Then install any ribbon cables from the internal
peripheral controllers to the disk drive(s) and
port connec-
tors. Be sure the red or blue stripe along the edge of the ribbon
cable is connected to Pin 1.
l - 6
2.0
Copyright@
Mylex Corporation
