Mylex FlashPoint BT-930, Installation Manual And User'S Manual

Page: 39 / 70

Adapter and Device Configuration
Manual No. 3000863 3-13
Figure 3-11. Switch Settings Window
See Table 3-3 for a list of the switch settings and their values. Default values
are shown in
BOLD ITALIC TYPEFACE .
Table 3-3. SCSI Device Configuration Parameter Settings
Option Value Description
SCSI ID 0- 7 Use this option if you need to change a SCAM
device’s SCSI ID on the SCSI bus. The
FlashPoint host adapter’s ID is set to 7 by
default.
Negotiated
Rate Async
Sync 5 MB/s
Sync 10 MB/s
Sync 20 MB/s
This is the transfer data rate that the host
adapter will attempt to establish with the target
device.
Note: If you experience a system hang
condition or data corruption, lower the
negotiated rate to attempt to remedy the
problem. If you are connecting an
Ultra SCSI device be sure to change the
negotiated rate to 20 MB/s.
Wide Negotiation
: -