Mylex Disk Array controller Software Kit 2.01, Installation Manual And User'S Manual

Page: 165 / 172

External RAID Support Enabling
Manual No. 771929 D-5
A
P
P
E
N
D
I
C
E
S
D
Running GAMCONFG
The default GAMCONFG command line is set to do the following when
GAMCONFG is enabled:
• Scan only channel 0 of the SCSI HBA [-c 1];
• Defines 16 targets that can be scanned (IDs 0 through 15) [-t 16];
• Of the 16 total target IDs, scan all target IDs.
[-T 1111111111111111]
If you accept these settings and require no changes, simply save the file and
reboot the server. GAMCONFG will run automatically at system startup
with the default settings.
-T Values = 1 = scan
0 = do not scan
Default = -T 1111111111111111
Examples:
gamconfg -T 1111111101111111
(scan targets 0 through 6, do not
scan target 7
a
, scan targets 8
through 15)
gamconfg -T 00110
(do not scan target 0,
scan
targets 1 and 2, do not scan
targets 3 and 4)
Define Specific Targets to Scan:
Defines specific target IDs that
will
be scanned on the generic
controller. Each placeholder in the
value represents a specific target
ID, with the right-most placeholder
representing target ID 0. The value
at each position determines whether
that target will be scanned (1) or not
scanned (0).
a. Target ID 7 is usually the target ID of the SCSI Host Bus Adapter itself and
need not be scanned unless a different target ID is used for the HBA.
Table D-1. Command Line Parameters and Their Functions