6 |
| 7
INSTRUCTION
MANUAL FOR MODELS
| SPECIFICATIONS
Model No.
RATED VOLTAGE
RATED POWER
MY0210R
AC230V, 50Hz
1000W
MY0215R
AC230V, 50Hz
1500W
MY0220R
AC230V, 50Hz
2000W
| STRUCTURE AND PARTS
1
2
3
1 - Out-let
2 - Body
3 - Control panel
| INSTALLATION ON THE WALL
ø 10mm
L
≥300mm
130mm
176mm (MY0210R)
326mm (MY0215R)
496mm (MY0220R)
≥
300mm
≥
300mm
≥
300mm
≥
300mm
MY0210R
MY0215R
MY0220R
Image 1
Image 2
Image 3
Image 4
Figure 1
• For wall mounting, carefully remove the already constructed hanging bracket from
the rear of the heater by turning the two plastic securing grips located at the top of
the bracket. It is good practice to remove the bracket and replace a few times so you
are familiar on how it attaches before securing to the wall.
• Using the hanging bracket as a template, place the hanging bracket level against the
wall as a guide ruler (please make sure the holes are parallel level), use a marker
pen to mark the hole position. Image 2 on Figure 1 above.
• Drill holes on the wall with Ø10mm drill bit and insert the plastic wall plugs. Image 2
on Figure 1 above.
• Securely fasten the hanging bracket to the wall with the screws provided. Make sure
the hanging bracket is in the correct direction. Image 3 on Figure 1 above.
• Gently insert the bottom of the heater to the hanging bracket first and then push the
top of the heater body onto the hanging bracket. It is good practice to try attaching the
hanging bracket to the heater and taking off, so you are familiar with how it at-taches
and detaches.
• When the heater is attached to the hanging bracket, secure into place by turning the
two plastic securing grips. Image 4 on Figure 1 above.