Mycond ABS 12A, Installation Instructions Manual

Page: 10 / 19

www.mycond.co.uk
9
1.
Plastic shell dismantling for ABS wall mounted mode
Step one:
Unplug the screw cap on
the grill
Note:Please do not force these operations over to avoid damage to the buckle
Screw cap
Step two:
Use a Phillips screwdriver
to twist the screw
Twist the screw
Step three:
pull down the left and right
buckle on the grille
Left and right buckle
Step four:
Open up the grille
Step five:
Use a Phillips screwdriver
to twist the screw
Twist the screw
Step Six:
Move up the right side of
the plate
Side plate
Step Seven:
Move left the right side of
the plate Step Eight:
Remove the right side of
the plate
Side plate
Side plate
Up
Down
Left
Right
IV Installation
DEHUMIDIFIER
2.1. To get enough air for ventilation of the unit, the installation position should be with good
ventilation.
2.2. The installation position can hold the outdoor unit without noise and shake.
2.3. No sunlight to the unit. Set an awning if necessary.
2.4. The water from rain and defrosting can be discharged in the installation position.
2.5. The unit will not be covered by snow in the installation position.
2.6. The discharged air will not face strong air in the installation position.
2.7. Assure the noise caused by the unit ventilation and operation will not affect the
neighbour.
2.8. The installation position will not be affected by garbage, oil and mist.
2.9. The unit will be damaged under the condition with oil(engine oil), salt(sea area)
and sulfide air(near thermal spring and refining factory).
2.The requirement of installation place
3. Installation requirement
3 .1. The unit can be installed in the balcony, roof, floor or any other convenient place and reliable
load-bearing.
3.2.Airiness place.
3.3.No heat radiation or other heat source place
3.4.Should be set up shed against the snow in winter.
3.5.Barrier-free at the air inlet or outlet place.