ASSEMBLY
PUNCHING
COIL INSERTING
1) Place your on top of a sturdy table.
2) Install Punch Handle and tighten screw.
3) Plug in the power adapter (for models equipped with Electric
Roller).
COIL CRIMPING
FEATURES
Electric Roller Switch
(available on RE & OE
models)
Electric Roller
(available on RE & OE
models)
Punch Handle
Depth
Margin
Guide
Side Margin Guide
Waste Drawer
(below machine)
Paper
Entrance
1
2
3
1. Use Depth Margin Guide to set the preferred punching margin.
2. Move the Side Margin Guide to center the holes on your documents.
3. Insert the documents (10 sheets of 20lb paper max) and press down on
the Punch Handle to punch holes, then release back to original position.
Repeat Step 3 as needed.
4. Manually insert the coil into the first few holes.
5. For R/O models, manually insert into the rest of the holes (not pictured)
6. For RE/OE (with Electric Roller) models:
a) Press the Electric Roller Switch to turn on the roller.
b) Hold the document evenly against the roller, pressing slightly
against roller. After last hole insertion, remove the document
from roller to stop binding, then turn off Electric Roller Switch.
4
6a
6b
7. Cut and crimp both ends of the
coil with coil crimpers (not included).
7
Power Adapter
(available on RE &
OE models)
