DEVICE DISCOVERY:
1. Close your garage.
2. Ensure the green LED light on the Switch Sensor is on. If not you need to adjust the Switch Sensor
upwards until you see the green light. Tighten the Switch Sensor in this position.
3. Now open the garage door and adjust the Switch Sensor forward until you see the green light
on the open switch. Repeat this a few times and ensure you get the green light every time
and adjust and secure the Switch Sensors one final time.
3. Discover the
Universal Garage Door Control
Unit to your Controller by logging on to your
Remote Account and accessing clicking on the ‘ACCOUNT SETTINGS’ tab.
Click the ‘DISCOVERY’ tab in this section and press the
‘START DISCOVERY’
button.
4. Press the
‘DISCOVERY’
button on the rear of the Control Unit and wait until the device
is registered and then press the
‘STOP DISCOVERY’
button.
5. Go to the
Device Overview
page and make sure that the
Universal Garage Door Control
Unit appears in the Device List.
6. Now press the small ‘TEST BUTTON’ on the front of the Control Unit. Your system should initialize.
A second press should close or open your garage door.
FRONT OF CONTROL UNIT
REAR OF CONTROL UNIT
DISCOVERY BUTTON
STATUS INDICATOR
TEST BUTTON
3
4
