Get your free training guide and
activate your warranty at mypawsbestfriend.com
6
Red light will blink for 4 seconds. The Clicker Collar™ is now being
linked together with the remote.
To turn the Clicker Collar™ OFF
,
press and hold the on/off button for 3
seconds. A beep will sound indicating the deactivation of the unit, and the Red
light will flash four more times.
When worn by your dog the Clicker Collar™ will automatically go into sleep
mode if not activated by the remote or no movement is detected for longer than
30 seconds.
The Clicker Collar™ takes 3 seconds to code with the remote when coming out
of the sleep mode.
Note:
When done correctly, the red LED light on the Clicker Collar™ will flash
every 3 seconds. This demonstrates that it is fully functioning.
Battery Replacement
1.
Replace the batteries on the remote by sliding the battery cover open on
the back.
2.
Insert 3 AAA batteries correctly by paying attention to the positive and
negative connectors. Incorrect installation of the batteries will cause
damage to the unit.
3.
Replace the cover.
4.
The batteries inside the Clicker Collar™ are permanently installed and
therefore not replaceable.
The Remote Buttons
1. Flashlight
: Push down the button to activate the
flashlight. Push down again to switch the flashlight
off. Remember the flashlight is a value added option
and it was purposely designed to be dim because if it
is used too much it will drain the batteries of the
remote.
2. Mode
: Push down the button to select the Click,
Vibration, or Stimulus mode. The stimulus mode will
not work unless the nonconductive comfort guards are
removed and the conducting prongs are attached.
3. OK
: This is used to send the selected signal to the
Clicker Collar™. The remote will transmit a signal to
your best friend for as long as you hold the button