The Auto STAY Arming feature helps cut down on false alarms in the event that you arm the system to 3—AWAY, but fail
to leave during the exit delay time. Here’s how it works:
If you arm the system to Level 3—AWAY, and do not leave the premises within the exit delay time:
If feature
turned on
The system can tell that no one opened and closed a delay door within the delay time. It assumes that someone is
still inside and the panel will arm to 2—STAY to avoid a false alarm.
If feature
turned off
The system arms to Level 3—AWAY regardless of whether or not a delay door has been opened and closed. Your
movement inside the premises could activate a motion detector, causing an alarm.
Access Codes
The system requires a valid access code before it will process most commands.
System Master Code
There is one System Master code. The System Master code is used to enter the programming menus for your system.
The default System Master code is 1234. It is important that you change the default code.
Regular User Codes
There are 16 Regular User codes which act like keys to arm and disarm the system. If necessary, they can be assigned to
neighbors, baby-sitters, or repair persons for temporary use. Regular user codes can be changed in the programming
menus and are easily deleted from the system when no longer necessary.
Using the Programming Menus
Some system settings can be changed by you, the user, while other settings must be changed by the installer. To change
system settings, you’ll use the System Master code to enter a series of programming menus.
Programming Access Codes
User codes can be given certain attributes which determine whether the user can bypass a sensor or perform system
tests.
To change or assign a user access code:
1.
Enter the programming menus by pressing [9] + System Master Code.
2.
Press [1][0]nn[0] where nn is user 00 through 15.
3.
Enter the desired 4-digit code, then [#].
4.
[*]+[4] +[#] to exit the programming menus.
Note:
The system will not accept the same code for two different users.
To erase a user code:
1.
Enter the programming menus by pressing [9] + System Master Code.
2.
Press [1][0]nn[0] where nn is user 00 through 15.
3.
Enter the System Master code, then [#].
4.
[*]+[4]+[#] to exit the programming menus.
To assign Direct Bypassing to a user:
