4
EN
M1.5.MV500LV.NLFREN - 27062019
1 Safety instructions
•
Never insert fingers or any other objects through the grill guard when fan is in operation.
• Disconnect the fan from its power source when moving from one location to another.
• Disconnect the fan from its power source when removing guards for cleaning.
•
Be sure the fan is on a stable, flat surface when in operation.
• Do not use fan in windows. Rain and moisture may create electrical hazard.
• Close supervision is necessary when this fan is used near children, the elderly and pets.
•
Do not place the fan near an open flame, cooking or heating appliance, or hot surfaces.
• This fan should not be operated outside.
• If the power cord is damaged, it must be replaced by the manufacturer or a snap-on service centre in order to avoid hazard.
• The appliance must be disconnected from its power source during service and when replacing parts.
• The appliance must no be used in locations where adverse conditions prevail, such a the presence of corrosive or explosive atmosphere
(dust, vapour or gas).
•
To reduce the risk of fire or fatal electrical shock, do not expose to water or rain.
•
To reduce the risk of fire or fatal electrical shock, do not use this fan with any solid state speed control device.
• Never handle the fan or motor with wet hands or when standing on wet or damp surface or in water. Fatal electrical shock may occur.
• Do not alter the fan’s assembly.
• Be sure that both front and rear guard screws are completely tightened in locking position before operation.
2 Technical parameters
Model
MV500LV
Voltage
230 V
Power
180 W
Frequency
50 Hz
Diameter
500 mm
Air flow
100 / 115 / 120 m³/min
Speed
1050 / 1250 / 1350 rpm
Working temperature
-20 - +80 °C
Net weight
6.5 kg
Dimensions (l x w x h)
620 x 260 x 610 mm
3 Installation
Place the ventilator on flat, horizontal surface.
4 Operation
To adjust airflow upward or downward:
Tilt the fan head to the desired angle. This high velocity fan can be used alone or in conjunction with air conditioning. Rotating the fan head
upward serves to pull air from the floor and circulate it throughout the entire room.
Speed control:
Select air speed by setting switch to either HIGH, MIDDLE or LOW.
It is normal for the motor to feel warm to touch after continuous operation.
5 Cleaning
WARNING:
Disconnect power source before working on the unit.
1. Routine maintenance must be done every year.
2. When installing or cleaning the blades, take care not to damage or change the angle of the blades.
3. The guard and blades should be cleaned with soapy water and a damp cloth only.
6 Storage
Unused fans should be kept packed in well-ventilated storehouses with no corrosive gases.
copyrighted
document
- all
rights
reserved
by
FBC
