2/4
1
9
3
7
12
10
13
9
2
8
3
6
10
14
4
Using either the
carriage handle 13
or the
Iast slice device 4
push the
product
holder 3
back and forth to slice.
Always switch off the slicer and turn the
slice thickness control
clockwise to zero when not slicing.
CLEANING
This machine must be thoroughly cleaned after each day’s
operation or anytime it will not be used for an extended period
of time.
WARNING: UNPLUG MACHINE POWER CORD
AND TURN THE INDEX KNOB FULLY CLOCKWISE
BEFORE CLEANING THE SLICER.
Loosen the fixing screws and remove the
slice deflector 12
.
The product
holder
can be removed for an easy
cleaning rotating its handle counterclockwise
8
Using a mild soap and hot water solution and a clean cloth,
wipe all surfaces of the slicer.
Thoroughly rinse it with another clean cloth and fresh water.
Remove the
blade cover
removing the hand knob
7 .
When the slicer is not running, the
slicer thickness control 2
must be
set on zero (fuIly clockwise) to cover the
blade edge.
Always UNPLUG the power
cord before cleaning or moving
the slicer.
SLICING
PuII the
product holder 3
towards you until it stops and place the
product to be sliced on the
product
holder
tray. Lay the
last slice device
against the product and on the slicer
switch, press the pushbutton green or
red
9 .
Adjust the slice thickness rotating the
slice thickness
control.
The numbers
on the
slice thickness control
do not
indicate actual measurements but may
be used for reference to duplicate slice
thickness.
WARNING:
THE SLICER
BLADE
IS VERY SHARP, USE EXTREME CAUTION WHEN WORKING
NEAR THE
BLADE.
CAREFULLY wash both sides of the
blade
with the
slice thickness control
turned fully clockwise.
Wash the blade by wiping outward from the center.
ALWAYS rinse the
blade
thoroughly using fresh water and a clean cloth. Never use steel pads to clean
the
blade.
Wash and rinse the removed camponents before reassembling them.
DO NOT wash any slicer components in a dishwasher.
