MuxLab PRODIGITAL 500791, Operation Manual

Page: 11 / 47

HDMI/IP PTZ Camera Operation Manual
11
[Far] button (to focus on far objects) and [NEAR] button (to focus on near objects)
10. Camera Select Buttons
Press the button corresponding to the camera you want to operate with the remote controller.
11. # Button
Used in combination with other buttons
12. Set Camera IR Address Buttons
To set to Address1, press on [*]+[ ＃ ]+[F1] buttons
To set to Address2, press on [*]+[
＃
]+[F2] buttons
To set to Address3, press on [*]+[ ＃ ]+[F3] buttons
To set to Address4, press on [*]+[
＃
]+[F4] buttons
13. Reset (Clear Preset) Button
Clear preset: Erase a preset position
Press [RESET] + Numeric button (0-9)
Or: [*]+[#]+[RESET]: To erase all the presets
14. Pan/Tilt Control Buttons
Press arrow buttons to perform panning (Left & Right) and tilting (Up & Down). Press [HOME] button
to return the camera to the center (home) position
15. MENU
MENU: enter or exit OSD MENU
16. BLC (Backlight Compensation) Button
BLC ON/OFF: Press this button to enable the backlight compensation. Press it again to disable the
backlight compensation. (NOTE: Effective only in auto exposure mode)
Note: If there is a light behind the subject, the subject will become dark. In this case, press the backlight
ON / OFF button. To cancel this function, press the backlight ON / OFF button again.
17. P/T RST
Press this button to automatically re-calibrate pan and tilt.
18. Screen capture function
Manual screen capture : To activate the screen capture function, press the [F4] key on the remote control,
a "Freeze" message will be displayed in the upper left corner of the screen, after 5 seconds, this message
will disappear. If you want to manually cancel the screen capture function, press the [F4] key on the
remote control, an "Unfreeze" message will be displayed in the upper left corner of the screen, after 5
seconds, this message will disappear.