© MuxLab Inc. 2019 94-000862-A SE-000862-A
Transmitter, to the 10Gig port on the Receiver. If transmitting over the network, use a 10Gig
Ethernet Switch between the TX & RX units.
6.
If the configuration is a point-to-multipoint or multipoint-to-multipoint:
a)
You will need to use an Ethernet Switch with Gigabit ports and DHCP Server support. In addition
IGMP Protocol support is required for the multipoint-to-multipoint case.
Verify that the
Ethernet Switch is configured correctly and that the DHCP Server is enabled and that the
IGMP Protocol is enabled for multipoint-to-multipoint applications
.
b)
Connect all Transmitters and Receivers to the Ethernet Switch.
7.
Connect the 12 VDC power supply to each Receiver and to an AC power outlet. Next connect each
Transmitter in the same manner. If power is present, the green power LED on each Transmitter and
Receiver will illuminate.
Note: Power ‘ON’ the 3G-SDI / ST2110 over IP uncompressed gateway converter only after all
data connections have been made.
8.
Power ‘ON’ the 3G-SDI equipment and verify the image quality.
9.
The 500767 provides a 1GB Ethernet port to connect additional network devices (e.g. RestAPI control
software).
10.
This product supports RS232 for remote control on end devices.
11.
The following diagram illustrates a typical point-to-multipoint LAN configuration.
