© MuxLab Inc.
Active VGA Managed Receiver Installation Guide
Page 15
3.5. Installation
Procedure
In order to install the product, please follow the steps
below:
1.
Place the Active VGA Managed Receiver in its final
location (see Section 3.4 for physical installation
details).
2.
Connect the UST/STP Cat 5e/6 cable from the
Dispatcher (or Repeater Hub) to the LINK IN port
located on the Receiver’s back panel.
3.
Connect RS232, Audio, and VGA cables from ports
on the Receiver’s back panel to the display device.
OPTIONAL: If the Receiver is being connected to
two
display devices, connect a second set of
RS232, Audio, and VGA cables from ports on the
Receiver’s front panel to the second display
device.
OPTIONAL: If cascading Receivers, connect a
UST/STP Cat 5e/6 cable from the upper-level
Receiver’s CASCADE OUT port (located on its
back panel) to the lower-level Receiver’s LINK
IN port (located on its back panel).
4.
Connect the Receiver’s power supply and power up
the display device(s).
5.
Ensure that the source and appropriate display
devices are on. Images should appear on the
displays.
