ValueJet Print Server Operation Manual
12
Troubleshooting
12-2
12-1
Troubles for Installation
(1) Cannot print even after the setting is completed
1: Make sure that the target ValueJet printer is the printer listed below.
VJ-2638, VJ-1638, VJ-1638W Firmware Version 2.06 or later
2: The panel display and the instructions are shown below.
Status 1: Panel display “Ready to Print” or “Print Ready”
Please check the IP address setting.
-VPS -
“Connection settings” Tab
Please set the IP address of the printer.
☞
9-3 VPS Settings
Check if you set the correct IP address on VPS.
-
“Software RIP”
Please set the IP address of the PC
with “VPS” installed.
(When the setting is performed according to the manual, the IP address is
the same as the IP address of PC with RIP software installed)
Refer to the manual attached to Software RIP.
Status 2: Panel display is “Ready to Print” or “Print Ready”
When the setting of Status 1 is correct, check if the VPS operates properly.
☞
9-4
VPS Status
Status 3: Panel display is “Receiving”
The setting of Windows Fire wall is required.
☞
5
Firewall Exception Setting
This may be due to the restriction for network, and the influence of resident software
for switching. Please check the operating manual of the installed software.
This may be due to the protocol setting of software RIP.
☞
6
Software RIP Setting
NOTE