-3-
CS3007-03
4.
Cleaning of cleaning wiper and the circumference of the cap
4
1
3
2
DO NOT touch the absorber
(the yellow portions in the illustration right)
Use the cleaning stick to clean the left side
surface of the cleaning wiper (a black rubber
part).
Clean the right side surface of the cleaning
wiper.
Use the cleaning stick to remove the ink and
dust on the circumference of the cap.
Close the front cover slowly, holding it by the
places shown in the picture and using both
hands.
Next finish the daily maintenance.
Cleaning required
2
3
1
Look at the bottom side of the carriage.
Check if dusts and ink deposit are adhered.
Print head circumference (silver metal part)
Print head guide part (black plastic part)
Use the cleaning stick to remove the ink and dust on the bottom of the carriage.
Print head circumference (silver metal part)
Print head guide part (black plastic part)
Next clean the cleaning wiper and the cap circumference.
3.
Cleaning of print head circumference
Print head circumference
Print head guide part
Cleaning required
DO NOT touch the surface of a print head (the yellow portions in the illustration below)
Ú
If maintenance cleaner is splashed onto the printer,
use a paper towel to wipe it off.
Ú
Before proceeding to the next step, if the cleaning stick gets dirty while cleaning, submerge the foam tip
of the stick into the maintenance cleaner in the cup to clean it.
Ú
If the dirt does not get off, change the cleaning stick and then proceed to the next step.
