MUTOH ValueJet VJ-1628X, Operation Manual

Page: 247 / 358

VJ-1628X OPERATION MANUAL Panel setup menu
5.1 Setup menu 247
5.1.28 Start Feed Menu
If you set the start feed beforehand, you can change the margins between the print results.
NOTE
• When the media roll surface becomes wavy due to the influence of the pre-heater, set a wider
margin before printer starts to stop the degradation of print quality.
• When using the take-up device and setting the “start feed” as less than 0, set the “margin between
pages” as “narrow” . If it is set as “Normal”, the settings for “start feed” is not applied correctly.
5.1.6.2 Page Gap menu
5.1.29 Heater Control menu
You can set the heater operations based on your usage environment.
If the media becomes wavy while printing due to heat, setting the heater operations may improve the
results.
Setup Item Description Setup Item
Start Feed -10 mm to <0 mm> to
500 mm
• When the value is bigger than 0: the margins are bigger than
when it is set to “0”.
• When the value is 0: the margin between print results does
not change.
• When the value is smaller than 0: the margins are smaller
than when it is set to “0”.
— • [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu
Setup Item Description Setup Item
Heater Ctrl <Normal> Normal heater operations are performed. When the media
does not become wavy, use this setting.
Fixer When you want to shorten the printing time and prevent the
media from becoming wavy, use this setting.
Dryer Use this setting if you want to curb waviness of the media
without deteriorating the drying performance for the print
result when using the take-up device.
—
• [Enter] key: saves the setting and shifts to the previous
menu.
• [Cancel] key: cancels the setting and shifts to the previous
menu.
5.1 Setup menu