Plaits requires a
-12V/+12V
power supply (2x5 pin connector). The red stripe of the ribbon cable (-12V
side) must be oriented on the same side as the “Red stripe” marking on the module and on your power
distribution board. The module draws
50mA
from the
+12V
rail, and
5mA
from the
-12V
rail.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
This device meets the requirements of the following standards: EN55032, EN55103-2,
EN61000-3-2, EN61000-3-3, EN62311.
A. Model selection buttons
and LEDs displaying the active model. Each button cycles through a bank of
8 models. The second bank is focused on noisy and percussive sounds.
Mutable Instruments | Plaits
1 of 11
