Installation
Kinks requires a
-12V / + 12V power supply
(2x5 pin connector).
The ribbon cable connector
must be aligned so that the
red stripe of the ribbon cable
(-12V) is on the same side of
the module’s power header as
the “Red stripe” marking on
the board. The module draws
25mA from both the +12V and
-12V supply rails.
Kinks happily accepts both
audio and CV signals.
Online manual and help
The full manual can be found
online at:
mutable-instruments.net/mod-
ules/kinks/manual
For help and discussions, head to:
mutable-instruments.net/forum
Kinks
Mingling and
mangling
Please refer to the online manual
for detailed information regarding
compliance with EMC directives
