6.
WAN Access IP Address
: If you want to limit the remote SNMP access to specific
computer, please enter the PC’s IP address. The default value is 0.0.0.0, and it means
that any Internet connected computer can get some information of the device with SNMP
protocol.
Afterwards, click on “Save” to store your settings or click “Undo” to give up the changes.
3.4.4 Routing
If you have more than one routers and subnets, you will need to enable routing table to allow
packets to find proper routing path and allow different subnets to communicate with each other.
The routing table allows you to determine which physical interface addresses are utilized for
outgoing IP data grams.
1.
Dynamic Routing
: Routing Information Protocol (RIP) will exchange information about
destinations for computing routes throughout the network. Please select RIPv2 only if you
have different subnets in your network. Otherwise, please select RIPv1 if you need this
protocol.
2.
Static Routing
: For static routing, you can specify up to 8 routing rules. You can enter the
destination IP address
,
subnet mask
,
gateway
, and
hop
for each routing rule, and then
enable or disable the rule by checking or un-checking the Enable checkbox.
Afterwards, click on “Save” to store your settings or click “Undo” to give up the changes.
51
