NOTE: Ensure there is no gap between the cap and the inflator shoulder.
Step 3 - Install new handle (CO2 cylinder) by rotating clockwise into inflator until firmly secured
(Fig. 13). Ensure the cylinder has not been pierced.
FIGURE 14
FIGURE 13
Step 4 - Check to be sure service indicator is green inside clear cap and the green indicator clip is
firmly attached to the activation lever (Fig. 14).
REPACKING
Step 1 - Lay flat on clean dry surface, handle side up (Fig. 15).
FIGURE 16
FIGURE 15
Step 2 - Fold the left cell lobe
under
the right cell lobe at the FOLD#1 line (Fig. 16). Ensure the
“Jerk to Inflate” tab is placed beside the cell.
Step 3 - With your left hand, fold the J end over to form the letter I at the FOLD#2 line (Fig. 17).
FIGURE 18
FIGURE 17
Step 4 - Fold the cell, at the FOLD#3 line, down to the inflator and hold down with your right hand
(Fig. 18).
Rescue Stick
™
Owner’s Manual
7
Jerk to
Inflate Tab