musikelectronic geithain TS37KSP, Instructions For Installation And Use Manual, Page: 19 / 32

INSTALLATION AND OPERATION
17
musikelectronic geithain GmbH TS 37SP / TS 37KSP
7 Installation and operation
During installation ensure sufficient convection at the heat sink.
7.1 Mounting and positioning
7.1.1 Changing the coverage angle of the horn driver
The horn drivers are designed with a square horn mouth and can be rotated to change the coverage
angle. By default, the horn drivers are built-in for a wide horizontal coverage angle.
To widen the coverage angle of the horn driver vertically, the horn can be rotated in the housing.
This reduces the horizontal coverage angle. For this purpose, the screws (PH 2) at the top and
bottom of the device must be removed, which hold the foam-covered front grille. The grille can then
be removed carefully. The horn is released by removing further screws (PH 2) and then rotating it
by 90°. Afterwards the horn is screwed back on, the grille is placed on the device and also screwed
back on.
7.1.2 Instructions for mounting and suspension of speakers
Refer suspending the speakers to trained and qualified personnel.
Heed all warnings and instructions of the speakers and mounting accessories as well as national
regulations.
Every speaker is to be suspended with a second independent flying point. This applies also to speakers
principally suspended on two flying points. The additional protection suspension has to be attached
in that way that in case of failure of the primary suspension the secondary suspension is holding
the speaker without falling or swinging. Ensure that all connections are secured to prevent their
detaching on their own and that only admissibly statically tested and sufficiently sized connecting
devices, ropes and chains are used.
7.1.3 Mounting instructions for speakers
Speakers are to be mounted in a way, so that they cannot fall and cause damages to environment or
persons. Therefore stacked speakers are to be secured with safety straps. Connecting cables have
to be installed so that nobody trips.
Stability of stacked systems (including stands and distance rods) is ensured, when the following
requirement is fulfilled:
Stacked systems may not fall even if they are inclined more than 10° in any direction. To fulfil this
requirement take measures to achieve compliance. One possibility is strapping the stacked speakers
to a solid base or using safety straps.