musikelectronic geithain RL 940, Instructions For Installation And Use Manual, Page: 12 / 20

POSITIONING
10
musikelectronic geithain GmbH RL 940 / RL 940C
5.4 Alignment of the center speaker RL 940C
In order to allow a perfect alignment of the center speaker RL 940C to the listening position, three
height-adjustable feet, consisting of an M8 or M10 threaded bolt and a support surface supported in
the ball joint, are located in the housing bottom of the loudspeaker. The design ensures that the feet
of the feet are always flush with the ground at every adjustable tilt angle. The M10 threaded bolt
of the front foot has a ejection length of 65 mm (2.6″) and therefore a maximum inclination angle
of 15° upwards is possible. Twist the two rear legs, with M8 threaded bolts and having a screw-in
length of 15 mm (0.6″) , out of the bottom of the enclosure only so that the support surface of both
feet can move freely in the ball joint. As a result, these supporting surfaces can also assume the set
tilt angle.
When aligning the RL 940C, pay attention to the maximum ejection length of the heigh-adjustable
feet as they can be completely screwed out of the enclosure (see the next figure).
Do not operate the center speaker without the preassembled height-adjustable feet, otherwise air
escapes through the threaded holes, affecting the reproduction qualtiy.
When setting up the center speaker , make sure that there is at least 5 cm (2″) space above the
loudspeaker.
max. 65 mm
max. 15 mm
15°