Musicom Lab EFX LIRE6V, User Manual, Page: 5 / 7

EFX LITE 6M Audio Controller User Manual 5
restart.
ྜྷG Follow the same procedure ྙ ~ ྜG for Loop6. In case of the Loop6, The switches are MODE and P2.
NOTE : The initial default setting is 'L'
6. Popping Noise Reduction Control
The EFX LITE 6M Audio Controller is based on relay switching. This method is utilized to route the audio
signal with absolutely no tone coloration or degradation. The disadvantage of relays is that they can produce
a slight popping noise when they switch on/off. The Popping Noise Reduction Control is excellent for
reducing this popping noise.
ྙG Apply power while holding the MODE and P3 switches down.
ྚG The display will show 'n' or 'F' and the LED above P3 switch will flash. 'n' means On and 'F' means Off.
ྛG Press the P3 switch to turn Popping Noise Reduction Control on/off.
ྜG This setting will store into the EEPROM memory and the EFX LITE 6M Audio Controller will automatically
restart.
NOTE
- To use the Popping Noise Reduction Control, connect the MUTE OUT jack to the amplifier input jack. Refer
to the basic connection drawing on page 2.
- The initial default setting is 'n'
7. Link DATA Send / Receive
7.1 DATA SEND
ྙG Apply power while holding the P3 and P4 switches down.
ྚG The display will show 't' and the LED above P3 switch will flash.
ྛG Press the P3 switch to transmit DATA to other unit or PC through MIDI OUT jack.
ྜG When the DATA sending is successful and the EFX LITE 6M Audio Controller will automatically enter the
DATA RECEIVE mode.
7.2 DATA RECEIVE
ྙG Apply power while holding the P2 and P4 switches down.
ྚG
The display will show 'r' and the LED above P2 switch will flash.
ྛG
The EFX LITE 6M Audio Controller is ready to receive the DATA from other unit or PC through MIDI IN
jack.