Primo preamplifier
REMOTE CONTROL
Issue 1
Page
8
of
12
Remote control Handset (supplied with the battery already installed).
The Primo remote control shown below enables functions from this unit to be operated from a convenient distance.
Equivalent buttons on the remote control have the same functions as those on the front panel of the unit. Other
functions are only available by remote control.
As the handset uses an invisible infra-red light beam, the front edge must be pointed directly towards the receiver
window at the front of the player, without visual obstruction between them.
For reliable remote control operation, the Primo Preamplifier should also be positioned so that direct sunlight,
fluorescent or other bright lights do not fall directly on the IR receiver lens (see P.7). Such light can interfere with
remote control operation and/ or maximum operating range.
If the range of the remote control greatly decreases, replace the battery, Lithium button type CR2450.
Please dispose of used batteries in accordance to local regulations.
Changing the Battery
If the remote fails to operate the Primo
functions correctly, or a substantial
reduction in range is observed, the
battery may be exhausted.
1. Remove the six screws in the base of
the remote control.
2. Remove the base to gain access to the
battery holder in the bottom left of the
remote.
3. Gently Lift the spent battery from the
holder.
4. Discard the spent battery according to
local regulations.
5. Replace with a new CR2450 Lithium
battery.
If there are any problems with changing
the battery please contact the dealer for
assistance.
RC5 codes used by this remote control
HEX DECIMAL
SYSTEM
CODE FOR
PREAMP
10 16
POWER
0C 12
MUTE
0D 13
VOLUME
▲
10 16
VOLUME
▼
11 17
GAIN
22 34
CD
01 1
TUNER
02 2
AUX 1
03 3
AUX 2
04 4
TAPE
05 5
POWER – Switches unit to
standby mode.
MUTE – Mutes outputs
until pressed again
VOLUME
▲
– increases
volume
VOLUME
▼
– decreases
volume
GAIN – Selects overall
gain
CD – Selects CD input
TUNER – Selects TUNER
input
AUX 1 – Selects AUX 1
input
AUX 2 – Selects AUX 2
input
TAPE – Select TAPE input
Important notice-
The remote control supplied is expensively machined from solid aluminium.
Pleas take great care of this remote control as it would be costly to replace.
