Issue 1
Page 8 of
13
OPERATION
SINGLE-ENDED (RCA) INPUT
To use the RCA
INPUT
, connect RCA source outputs to the
INPUT
RCA sockets. Make sure the
BALANCED/RCA
switch is set for
RCA.
BALANCED/RCA switch set to RCA
RIGHT
Speaker
+
-
LEFT
Speaker
+
-
LEFT RCA output
Pre-amplifier
RIGHT RCA output
RCA leads connection diagram.
(Trigger and mains leads omitted for clarity).
Note: The two RED speaker terminals are internally connected together. Similarly, the two BLACK speaker
terminals are also internally connected together.
The diagram above shows the speakers connected to the LEFT hand output posts. It is also perfectly
acceptable to use the RIGHT hand output posts as
they are exactly the same connection internally
.
IMPORTANT: BALANCED/RCA switch
The
BALANCED/RCA
switch (see page 7) is included to minimise noise when using the unit in RCA mode. In
most cases it will operate in
BALANCED
position on RCA inputs with no appreciable audible increase in noise.
There is no harm in operating the unit in this way.
However it is important, that if using the XLR (
BALANCED
) input, the switch
must
be set for
BALANCED
. If the
switch is not set for
BALANCED
on an XLR input, a 6dB reduction in loudness will occur and the benefits of
BALANCED
operation
will be lost.
