Issue 1
Page 6 of
14
INSTALLATION
Introduction
Congratulations on the purchase of the new M6PRE preamplifier. Great attention has been paid to internal
layout, isolating each circuit section to prevent possible interaction.
The unit features a finely tuned and tweaked preamplifier, for smooth sound coupled with low noise and virtually
no distortion.
The preamplifier consists of two monoblock balanced amplifiers with generously rated supplies for the absolute
best in separation and imaging. Low distortion and very quiet they will deliver all music types exactly as the
artist originally intended.
The resultant performance achieved by this unit is among the best in the world. It has excellent signal to noise
ratio, low distortion, wide bandwidth and dynamic range, with extraordinary resolution and fine detail.
Cleaning
Before cleaning the unit, switch off power at the mains switch and remove the mains plug from the wall socket.
Clean the cabinet and remote control unit using a moist cloth. Using solvents, white spirit or thinners is not
advised, as they could damage the surface finish.
Installation
Position the M6PRE on a stable, horizontal surface where there is no risk of it being knocked, or subjected to
vibration such as from loudspeakers.
Important note:
The M6PRE must be protected from humidity – if the unit is moved from a cold place to a warm
room, leave the unit for an hour or so to allow sufficient time for the moisture to evaporate.
Power Connections
The M6PRE is supplied with a standard IEC mains cable which plugs into the IEC socket at the back of the unit
(see page 7)
Audio Connections
RCA Inputs:
Connect all RCA single-ended sources to relevant analogue inputs (see page 7 for more
information). Use good quality fully connected (signal and ground) coaxial phono cables for all RCA signal
connections.
XLR Inputs:
Connect any XLR balanced source to desired balanced analogue inputs (see page 7 for more
information). Use good quality fully connected (signals and ground) balanced XLR cables for all XLR signal
connections.
USB Input:
Connect a desktop or laptop computer directly to the M6PRE USB input to allow digital audio from
computer to be heard through the hi-fi. Use a good quality screened USB cable for very best results.
TAPE Output:
Direct loop through of
selected
source. The level of this output is unaffected by the volume
control, to pass on to a recorder or other equipment. It is also the ideal output for standalone headphone
amplifiers (incorporating their own volume control).
RCA Outputs:
Connect all RCA single-ended power amplifier(s) to RCA analogue outputs (see page 7 for more
information). Use good quality fully connected (signal and ground) coaxial phono cables for all RCA signal
connections.
XLR Outputs:
Connect any XLR balanced power amplifier(s) to XLR analogue outputs (see page 7 for more
information). Use good quality fully connected (signals and ground) balanced XLR cables for all XLR signal
connections.
