Issue 1: March 2005
A3.5 CD
Instructions for use
Page 13
of
16
SPECIAL
FEATURES
That track number will now appear in the
display :
Press
PROGRAM
again on the remote control
- the next program step is selected,
(prog 2)
and the track number reverts to zero ready for a
new entry :
SCAN INTRODUCTION
The scan-introduction function allows play
back of just the start of each track on the disc,
for instance to locate a preferred track by ear.
Press
INTRO
on the remote control, and if the
player has stopped, the display will show :
The first ten seconds (approximately) of each
track on the CD can then be played in sequence
by pressing either
PLAY/PAUSE
on the front
panel, or
PLAY
on the remote control.
Press
INTRO
again to cancel introduction
search mode. If
INTRO
mode is cancelled
while the A3
.
5 CD is still playing, the
remainder of the entire disc will be played.
PROGRAMMED PLAY
The built-in program memory allows you to
store up to 25 track numbers and then play
them back in the held order. Each track is
stored as a “step” in the program.
With the CD loaded and the player stopped,
first press
PROGRAM
on the remote control.
The following is then displayed :
On the remote control, press the numeric button
of the track number corresponding to the first
track you wish to store (number 3 for example).
Continue entering track numbers in the same
way up to a maximum of 25. If more than 25
tracks are attempted accidentally, the memory
will not accept any extra ones, and the display
reverts to “
prog 1
”.
Remember that when entering a single-digit
track number, there is a delay of about two
seconds before the display accepts the entry -
this is to allow time for a second button to be
pressed when a double-digit number is
required.
If an incorrect entry is made, say track 9 when
there are only 7 tracks available on the disc,
“
INVALID TRACK
” is briefly shown, and
the entry automatically cancelled.
If at any time you wish to add a track to the list,
press the
CLEAR
button to obtain the next step
number. Alternatively, to delete a previous
entry, press
CLEAR
a second time to remove
the last entry. Repeated pressing of
CLEAR
will then erase each step in reverse order.
When the last track number has been selected,
press
PROGRAM
a final time, then the
PLAY
button to start the program sequence.
(continued . . .)
(continued . . .)
