Music in Every Room Tenor Audio Mirror, Manual, Page: 8 / 10

Split the glass fropm the case as previously described.
Remove the side mounting aerial by removing the screws shown, push the aerial back through the
hole to remove, refit the screws and fit the blanking grommet fitted in the rear of the case.
2. Fitting the case into the recess
Drill through the case keyhole slot in the position shown “X” below. Drill all 4 plates (approx 2mm)
This position should be the centre of the screw when engaged in the keyhole slot.
Place the case in the recess, resting on the lower edge of the cutout. Pack up the bottom of the case
by 4mm for clearance. Accurately mark through the drilled holes onto the batons. Remove the case
and fix the mounting screws in the batons. Test that the case enters the cut out and drops down onto
the screws. It should be clear at the base and held securely to the wall. The gasket should fit snugly
into the recess.
3. Wiring
Mains: Fit a mains connection block between the wall batons. Retain the mains cable supplied with
the mirror and cut to appropriate length (aprox 1m)
LED & Demist:
The on/off proximity sensor will not be used. The LED/Demist on/off is rewired
through a separate switch. This could be next to the room light switch or alternatively a pull cord near
the mirror. Disconnect the LED sensor box (no longer used) from the incoming mains box and wire
the new switch. See diag over. Leave trailing wire of aprox 1m from the rear of the case. The cable
exists through one of the rear holes, gromet supplied. Fit a terminal box between the battons wired to
the external switch.