Cleaning a record
1.
Make sure the discharge tube clamp is tightly clamped to the tube.
2.
Using the supplied brush clean off any lose dirt or dust from the record.
3.
Place the record on the turntable and screw down the record clamp counterclockwise
until the rubber seal is securely over the record label.
To tighten the clamp turn the top of the clamp counterclockwise while
pressing the large disc onto the record label.
4.
Start the turntable. Put the proper amount of cleaning fluid on the surface of the
record and use the brush to apply a uniformly spread the fluid onto the record.
Gently hold the brush on the grooves during rotation.
5.
Turn the suction arm so that it is over the record and then turn on the vacuum.
6.
Adjust the amount of desired suction with the variable suction knob.
7.
Allow the suction arm to remove the fluid and dirt from the record surface. When
dry, turn the suction knob to its lowest setting, then switch off the vacuum and turn
the suction arm away from the record.
8.
Switch off the turntable and unscrew the clamp.
9.
Repeat steps 1 – 8 to clean the other side.
