ASSEMBLY
14
F-050406L
3. Attach the
engine stop cable
to the en-
gine. Models with Briggs & Stratton en-
gines are shown in Figure 5. Models with
Tecumseh engines are shown in Figure 6.
4. Make sure the
engine stop cable
moves
freely. If the cable does not move freely, re-
peat the above steps.
CAUTION: A cable that is bent or damaged
will not work correctly. Before you use the
unit, replace a damaged cable.
5. Attach the
cable
to the handle with the
cable fastener(s)
as shown in Figure 4.
CAUTION: If a cable fastener is missing, a
cable can be too near the muffler. Heat from
the muffler can damage the cable. Before
you use the unit, replace a missing cable
fastener.
WARNING: The blade will rotate
when the engine runs.
6. Hold the engine stop lever against the
handle. Slowly pull the recoil-start grip. To
attach the
recoil-start grip
to the
rope
guide,
twist the rope through the
rope
guide
mounted on the right side of the
handle Fasten with a
locknut
(Figure 7).
Figure 5
Engine Stop
Cable
Briggs
Engine
Engine Stop
Cable
Engine
Stop Cable
Figure 6
Tecumseh
Engine
Figure 7
Recoil-Start
Grip
Rope Guide
Locknut
15x116