Murphy PowerView PV780, Installation Manual, Page: 6 / 17

Mounting the Unit
1. Place the back side of the display through the opening in the dash.
2. Use the four screws to line up the unit with the drilled holes.
3. Push the unit through the opening and screws through the drilled holes until the back of
the case is flush.
4. Use the Nylock nuts provided to tighten unit to the dash. Use the appropriate wrench or
socket to tighten. Torque lock nuts to 8-10 inch pounds.
Flush Mounting the Dash
1. Cut the dash to allow for the display without bezel. Ensure x amount of materials is
available to ensure the display is properly secured within the dash. Torque the 6-32
Nylock nuts to 5 inch pounds.
2. Place the display behind dash and line up the four mounting holes on the display with
the holes in dash.
3. Install four bolts and tighten nuts.
Section 78 00-02-0860
2013-08-29 - 2 -