Murphy powerview pv350 r2, Installation Manual, Page: 6 / 20

00-02-0998 6 2016-06-15
Dash-Mounted Installation
Tools needed
•
Jig saw or
•
3.5” Hole saw or
•
3.5” knockout (chassis) punch
Preparing the Dash
Determine the location of the PowerView in the dash. Refer to
the Mounting Hole Options sheet at the end of this document
for the appropriate opening sizes.
Mounting the Unit
1. Place the dash gasket over the prepared dash
opening.
2. Place the back side of the display through the opening
in the dash.
3. Push the unit through the opening until the case is
flush.
4. Place the screw-on type mounting clamp behind the
dash and install on the unit until it is hand tight.