In order to consistently bring you the highest quality, full-featured products, we reserve the
right to change our specifications and designs at any time. The latest version of this
manual can be found at enovationcontrols.com.
BEFORE BEGINNING INSTALLATION OF THIS MURPHY
PRODUCT:
•
Read and follow all installation instructions.
•
Visually inspect this product before installation for
any damage during shipping.
•
Disconnect all electrical power to the machine.
Failure to do this before welding can result in
damage to the panel and/or its components.
•
It is your responsibility to have a qualified
technician install the unit and make sure the
installation conforms to local codes including, but
not limited to, double insulation and fire
containment.
•
Observe all Warnings and Cautions in each
section of these instructions.
•
The TEC-10 is designed for use in industrial
environments for monitoring and control which
include engine driven pumps, compressors,
grinders, chippers and rock crushers. Potential
difficulties may exist when ensuring
electromagnetic compatibility in other
environments due to conducted as well as
radiated disturbances.
Contact Enovation Controls Technical Service if you
have any questions or concerns at: +1 918-317-4100.
IMPORTANT! Improper use and operation of electronic
products can be dangerous. It is required that point-of-
operation guarding devices be installed and maintained.
All such devices must meet OSHA and ANSI Machine
safety standards. The manufacturer shall not accept
any responsibility for installation, application or safety of
systems.
