Murphy HelmView 450, Installation Manual

Page: 17 / 24

Addendum
How to Install a Configuration From a USB Drive for the HV450
1. READ ALL INSTRUCTIONS BEFORE CONTINUING!
2. Power OFF the display unit.
3. Insert USB drive with the configuration file into USB port.
4. Press and hold the top left button (continue to hold).
5. Power ON the display while continuing to hold the button a few more seconds then
release.
6. Use the keys next to up/down arrows to find the desired file.
7. Use the key next to the right arrow to select and continue. (The right arrow turns green,
press again to confirm. Exit by pressing the key next to the red left arrow.)
8. When the installation is complete, a check mark is displayed in the middle of the screen.
9. The unit will reset itself automatically and boot to the new configuration.
Section 78 00-02-0727
2015-04-16 - 13 -