Muratec MFX-2550 Guide, User Manual

Page: 314 / 327

1
2
3
4
5
6
7
Device Settings
Specifying Default Settings 7-49
„
List of Other Default Settings
Function Description Settings
Reference
page
Redial Attempts This sets the number of redials when the other
machine cannot be connected to, for example,
when the other line is busy. Set the redial
interval in “Redial Interval”. 0 - 14 time(s):
2 time(s) 3-21
Redial Interval This sets the redial interval. 0 - 5 Minutes :
1 Minute 3-21
Number of Rings This sets the number of times the machine rings
until fax reception starts when the reception
mode is set to Fax or Tel/Fax. The number of
rings becomes more than the set number when
the machine is in the low power mode. 0 - 10 time(s):
2 time(s) 3-36
Dialing Pause This sets the default dialing interval used when
the pause option is input. 0 - 10 seconds:
2 seconds 3-27
S-Fine Resolution This sets the scanning resolution to use when
super fine resolution is set for transmission.
When set to 600 dpi, the image quality will
be higher than with 400 dpi, but the machine
may run out of memory when performing the
transmission. 600 dpi
400 dpi 3-24
Rx Reduction Rate Select from “Auto”, which automatically selects
the magnification according to the length of the
document being received, or “100%” to have all
faxes printed out at the same rate of reduction. Auto
100 % 3-40
Reduction Margin This sets at what point the document printout
will extend to the following page if the document
being received cannot fit within the effective
recordable area. 0 - 3.3 in.:
1.6 in. 3-42
Paper Saving This sets the print method for received
documents. OFF
H-Page Rx
Duplex Rx 3-42
Quick Memory Tx If this is set to “ON”, fax transmission for
multiple documents will begin in order of page
when it has been scanned and stored. ON
OFF −
ECM Mode This mode enables any part of a fax that was
not transmitted correctly due to a line error
will automatically be resent.(The destination
machine must also have the same function.) ON
OFF −
Service Mode Do not set this. ON
OFF −
Prefix By registering frequently used fax numbers, you
can enter a fax number simply by pressing a
button.
Up to 40 digits can be entered for a prefix
number. Numbers, #, *, /P (Pause), and /T (Tone)
can be entered. (Not
registered) 3-27
Receive Time Stamp Prints the time that documents are received.
This enables you to accurately manage the
arrival time of received documents.
ON
OFF −
Auto Print Journal You can print a list of communication jobs. ON
OFF
Reserve print 6-7