25
|
© Munters AB, 2019
Step 14A
Fasten each of the joints in the single outer hole using (1) Short Bolt [AA], Washer [A] and Nut [DD], with the nut on the
side with the tabs. At the inner pair of holes of each joint attach (1) Cone Support Bracket to the inner hole using (1) Bolt
[AA], Washer [A] and Nut [DD] with the bolt head on the side with the tabs.
See Figure 14A
.
Figure 14A
Step 14B
Stand the cone sections on end and curl ends around to form cone with the Cone Support Bracket on the outside and the
tabs on the inside. Then insert the remaining tabs into slots so the tabs are inside the cone and fasten final joint using (1)
Short Bolt [AA], Washer [A] and Nut [DD], with the nut on the inside of the cone. At the inner pair of holes attach (1) Cone
Bracket to the inner hole using (1) Short Bolt [AA], Washer [A] and Nut [DD] with the bolt head on the outside of the cone.
See Figure 14B
.
Figure 14B
