Munters Rotem Communicator, Manual For Use And Maintenance, Page: 35 / 64

© Munters AB, 2018 35
Table 3: Address Configuration
Square 1 Square 2
Address 0 unmarked unmarked
Address 1 marked unmarked
Address 2 unmarked marked
Address 3 marked marked
7.1.2 D
ISPLAYING THE CONTROLLERS
•
Press
This screen displays all the controllers that are connected to the system.

- Represents a recognized controller

- No controller is recognized
NOTE: The letter 'F' indicates that communication to that house has been lost. The 'F' continues to
appear until the unit is reset (disconnect and reconnect the power).
7.1.3 L
ISTING THE NETWORK DEVICES
•
Select SYSTEM > Test > Network List.
•
Primary Found: Displays the number of primary units found in the network.
•
Secondary Found: Displays the number of secondary units found in the network.
•
Scan Network?: Use +/- key to select YES or NO and then press ENTER to scan the network
to find/remove primary or secondary units.
7.2 Channel/Signal tests
The following sections detail how to test the controller communication channels.
•
Testing the RS-232/485 channel
•
Testing the Radio RF signal
01

16
17

32
33

48
49

64
01

16
17

32
33

48
49

64
NETWORK LIST
PRIMARY FOUND: 0
SECONDARY FOUND: 0
SCAN NETWORK? NO
0
