© Munters AB, 2018
36
7.2.1
T
ESTING THE
RS-232/485
CHANNEL
•
Select
SYSTEM > Test > Wired 232/485
.
This menu tests the RS-232/485 communication channel.
Enter the required unit number and press ENTER to start and stop the test. The screen displays a shaded
box in the Tx when transmitting and a shaded box by the Rx when receiving (when functioning properly
the shading switches back and forth between the two boxes).
NOTE:
If the checkbox remains blank, check all connections between the Communicator and the
controller.
7.2.2
T
ESTING THE
R
ADIO
RF
SIGNAL
•
Select
SYSTEM > Test > Radio RF Signal.
This menu tests the RF communication channel.
Enter the required unit number and press ENTER. The screen displays the reception bar graph as well as
the measured signal reading once available (testing is continuous until exiting this menu).
COMMUNICATION
SET UNIT NUMBER: < 1>
GO, STOP USING ENTER.
Tx
Rx
RF TEST
SET UNIT NUMBER:
1