IceDry 800/1400
5
Operation
5.1 General
The dehumidifier is equipped with an operator panel that contains mode switch and LED indicators. The
mode switch of the operator panel has two operating modes:
MAN (Manual mode)
:
The dehumidifiers fans, rotor and reactivation heater operate continuously with full capacity.
AUT (Automatic mode)
- not applicable.
5.2 Safety
W
W
WARNING!
ARNING!
ARNING!
In the case of a power cut, the dehumidifier will restart automatically when the power supply is restored.
CA
CA
CAUTION!
UTION!
UTION!
At initial start-up or when restarting after a service stop, the main power switch must have been on for at least 12
hours before starting. This is necessary to remove any ice build-up inside the unit.
CA
CA
CAUTION!
UTION!
UTION!
Before starting the unit, the reactivation air inlet and wet air outlet must be thoroughly checked. Any ice must be
removed. To avoid malfunction, it is important to have clear air passage throughout the ductwork.
CA
CA
CAUTION!
UTION!
UTION!
To prevent damage to the fans, the unit must not be run for longer than a few minutes prior to setting-up the process
and reactivation airflows.
CA
CA
CAUTION!
UTION!
UTION!
Do not turn off the main power switch. This can lead to ice formation and malfunction of the dehumidifier.
5.3 Quick stop
The mode switch is used to start and stop the unit in normal operation. In case of an emergency, use the main
power switch on the dehumidifier, see section
.
CA
CA
CAUTION!
UTION!
UTION!
Only use the main power switch to stop the unit in the case of an emergency. The normal shutdown sequence will
not be followed. The fans stop and the heater can be very hot, which can result in damage to the heater and other
components close to it.
16
Operation
190TGB-1037-G1307
