5.8. Electrical connections
The dehumidifier is delivered with a 2.7 m long power cable, with a plug for connection to an earthed
outlet.
WARNING
All electrical installations must be done by an authorized electrician in accordance with
local regulations. An incorrect installation can cause electrical shock hazards and dam-
age to the unit.
The unit must never be connected to another voltage or frequency than what is speci-
fied on the identification plate. Too high line voltage can cause electrical shock hazards
and damage to the unit.
The unit must be connected to an earthed electrical outlet.
Do not operate the unit if the power cable or plug is damaged, risk of electrical shock.
CAUTION
In case of a fixed installation where the plug is replaced by a circuit breaker, make sure
that the fuse rating in the circuit breaker is correct.
The mains frequency can be adjusted, see the control system supplement.
5.9. Expanding the system
CAUTION
Never connect ComDry directly to a standard Ethernet network, even if the connector
type is the same (RJ45-8, modular connector). Doing so can damage both the ComDry
control system and/or the computer network.
All ComDry dehumidifiers are equipped with two CAN bus ports, located behind a cover next to the
power inlet. An indoor remote control, external humidity/temperature sensors or an external signal box
can be connected to these CAN bus ports.
Any of the above devices can be connected to either port. When no port is used the two empty termina-
tion plugs must be fitted to the ports.
ComDry M160L Dehumidifier
15
