mundoclima MUENR-30-H9T, Installation & Owner'S Manual

Page: 86 / 112

8.6.9 Installation of multi-module water system pipeline
CAUTION
Cooling capacity
_ ¦§¦^}
30 ＜ §¦‰}
90 ＜ §¦_^}
130
＜
§¦Œ_}
210
＜
§¦^Œ
325 ＜ §¦ _}
510 ＜ §¦„‘}
740
＜
§¦_^}}
1300
＜
§¦Œ}‹}
Total inlet and outlet water pipe inside nominal diameter
DN40
DN50
DN65
DN80
DN100
DN125
DN150
DN200
DN250
Table 8-10
Multi-module combination installation involves special design of the unit, so relevant explanation is given as follows.
1) Installation mode of multi-module combination water system pipeline
2) Table of diameter parameters of main inlet and outlet pipes
2) Applicable standard of water quality for the unit
PH value
Total hardness
Conductivity
Sulfide ion
Chloride ion
Ammonia ion
Sulfate
Silicon
Iron content
Sodium ion
Calcium ion
/
6.8~8.0
<70ppm
·Œ}}¸\]Œ ©`
No
<50ppm
No
<50ppm
<30ppm
<0.3ppm
No requirement
<50ppm
/
Table 8-9
Please pay attention to the following items when installing multiple modules:
- Each module corresponds to an address code which cannot be repeated.
- Main water outlet temperature sensing bulb, target flow controller and auxiliary electric heater are under control of
the main module.
- One wired controller must be connected on the main module (master).
- The unit can be started up through the wired controller only after all addresses are set and the aforementioned
;< ;< %W³< ;<<¦ }}³$K<;W>; <>;%
No.n module
No. (n-1)address No.1 module
No.0 address No.(n-1) module
No.(n-2) address
Pump
Drill dead hole at the position,
and move the total effluent
temperature sensor at No.0
address to the position
Fig.8-24 Installation of multi-module (no more than 16 modules)
- As the total water outlet temperature sensor (Tw), you must use total oulet temp. sensor (Tw) of the master unit
(sensor length is 10m) see the electrical diagram to locate it. The sensor must be located inside the sheath provided
for that purpose.
Tw
86