Place the battery in the unit and ensure the positive side of the
battery is in accordance with the polarity markings.(See Fig.3-7)
Set the correct time before operating. Batteries in the wired controller
can maintain the correct time during a power failure. When the power
is restored and the displayed time is not correct, replace the battery.
Fig 3-7
Fig 3-6
For switch box mounting, fasten the back plate on the switch box with
2 screws (M4x25) and fasten it on the wall with 1 screw (M4x20).
(Fig.3-6)
6. Battery installation
NOTE: Place on a flat surface. Be careful not to distort the wire
controller’s back plate by over−tightening the mounting screws.
Switch box
Back plate
Screw (M4×20)
Screws (M4×25)
46
3. INSTALLATION METHOD
Summary of Contents for KJR-120G2/TFBG-E-02
Page 2: ... ES EN 3 38 2 ...
