How To Install
How To Install
10
11
STEP 4: SETTING YOUR GATE
1.
The gap between the gate to the wall should be less than 2.6” (66 mm). If necessary,
adjust the lower hinge bracket using the wrench to its appropriate length. Then tighten
the nut against the tube by using the wrench.
Next, insert the gate’s lower hinge pin down into the lower hinge bracket on the wall
until it clicks.
2.
On the catch side of the gate, loosen the nut around
the lower adjustment rod using wrench. Extend the
adjustment rod by using the hex key to turn it clockwise
until it is seated in the lower catch bracket on the
wall. (The rod should fully depress the bracket’s center
button.) Then, tighten the nut against the tube by using
the wrench.
3.
Position the upper hinge pin
1/4” (6.35mm) from the wall. If
necessary, extend the hinge pin by
inserting the hex key into the end
and turning counterclockwise to
create the 1/4” (6.35mm) gap.
Upper hinge pin
<2.6" (<66mm)
<2.6" (<66mm)
Lower catch
bracket
Lower hinge pin
1/4"
6.35
mm
Lower
catch
bracket
Upper hinge pin
Press
hinge
lever
STEP 5: INSTALL UPPER HINGE (WALL BRACKET)
1.
Slide the upper hinge bracket into
upper hinge pin. Hold the bracket
against the wall so that it’s directly
above the lower hinge.
Use the lines of template “A”
as a guide to line up the hinge.
Trace the upper hinge bracket’s
position with a pencil. Remove
upper hinge bracket and place
it aside.
2.
Release the lower hinge pin by pushing the hinge lever toward the wall. Then lift the
gate to remove and place it aside.
Summary of Contents for MKSA0646-REV1
Page 28: ......