Customer Service
How to Use
10
HOW TO CLEAN
DE-SCALE
TROUBLESHOOTING
De-scale your Digital Warmer after every use to ensure residual deposits are removed from
the heating plate and the silicon seal. To de-scale, mix 0.5oz. (15ml) of white vinegar with
0.5oz. (15ml) of cold water and pour into the Warming Chamber. Allow liquid to stand in
the unit until any deposits (limescale) have dissolved. Discard liquid and rinse with clear
water, repeat "Clean Cycle" to remove any residual deposits.
NOTE:
To avoid bacteria
growth perform "Clean Cycle” and “De-Scale” daily. Any other servicing should be
performed by an authorized service representative.
Blinking display:
Digital warmer will not operate if tilted more than 30°. Place warmer on
a flat surface.
Display “E1":
Digital warmer is not responding to input command from the control panel
due to damaged temperature sensor.
Display show " E2":
Digital warmer is not responding to input command from the control
panel due to damaged heating element.
Overheat protection:
Power switch turn off after three consecutive beeps – circuit protection
detects rapid increase in internal temperature to prevent damage to the device.
Three beeps:
Digital warmer will power off due to limescale deposit build up on heating
plate or if milk has not been mixed thoroughly.
Always unplug unit and ensure that it is cool
before cleaning. Do not use scouring pads,
abrasives or solvents for cleaning; they may
damage the appliance and its surface. Place
the rubber plug back into the plug attachment
to prevent water intrusion and cause electrical
short during cleaning.
Digital Warmer:
Wipe all surfaces with a damp
cloth or sponge using mild liquid soap, rinse with
clear water. Allow to air-dry. Do not submerge unit
in liquid.
Adapters and O-rings:
Wash with mild liquid soap
and rinse with clear water. Allow to air-dry. Always replace O-rings to their proper location
(flat side down). Keep Dust Cover on when not in use to keep heating plate clean.
