Munchkin 37, Manual

Page: 11 / 64

How to Use How to Use
11
DE-SCALE
De-scale your digital warmer after every use to ensure residual deposits are removed from
the heating plate and the silicon seal. To de-scale, mix 0.5oz. (15ml) of white vinegar
with 0.5oz. (15ml) of cold water and pour into the Warming Chamber. Allow liquid to stand
in the unit until any deposits (limescale) have dissolved. Discard liquid and rinse with clear
water, repeat "Clean Cycle" to remove any residual deposits.
NOTE: To avoid bacteria growth perform "Clean Cycle" and “De-Scale” daily.
Any other servicing should be performed by an authorized service representative.
TROUBLESHOOTING
Blinking display: Digital warmer will not operate if tilted more than 30°. Place warmer on
a flat surface.
Display “E1": Digital warmer is not responding to input command from the control panel
due to damaged temperature sensor.
Display show " E2":
Digital warmer is not responding to input command from the control
panel due to damaged heating element.
Overheat protection: Power switch turn off after three consecutive beeps – circuit protection
detects rapid increase in internal temperature to prevent damage to the device.
Three beeps: Digital warmer will power off due to limescale deposit build up on heating
plate or if milk has not been mixed properly.