safety instructions
description of pictograms
1.
Avoid direct contact with water. For indoor use only.
2.
Suitable for outdoor installation.
3.
The fitting operates by means of a safety transformator. In case of fault, replace with a model with
the same specifications.
4.
The fitting is equipped with a fuse.
5.
Protection class 1: the fitting must be earthed.
6.
Protection class 2: the fitting is double insulated and does not require earthing.
7.
Protection class 3: the fitting is suitable only for low voltage, e.g. 12V.
8.
The detection area has the indicated dimensions.
9.
There are no serviceable parts in the unit, do not attempt to repair it.
10.
Do not mount the transmitter onto any metal surfaces or UPVC doorframe, as this will reduce the
operation range seriously.
11.
Do not immerse either unit in water.
12.
Do not mount either unit close to fireplace or expose to high temperature.
13.
Do not use different type of batteries in either unit. If leaving the unit for long period of time,
remove the battery from compartment to prevent leakage.
14.
Do not leave exhausted batteries in either unit. If leaving the unit for long period of time, remove
the battery from compartment to prevent leakage.
15.
Always use alkaline batteries as these will give longer service and are less likely to leak.
16.
Please dispose of old, defective batteries in an environmentally friendly manner in accordance
with the relevant legislation.
17.
Make sure that no naked flame sources, such as lighted candles should be placed on the unit.
18.
The unit should not be exposed to dripping or splashing and that no objects filled with liquids, such
as vases, shall be placed on the unit.
19.
CAUTION:
Replace only with the same or equivalent type of battery that is recommended by the
manufacturer.
20.
CAUTION:
Danger of explosion if the battery is incorrectly installed or replaced.
21.
Ensuring the battery polarity match the internal markings.
22.
Operating Temperature
23.
Operating range is up to ….
24.
Default (factory preset)
25.
Isolate the wire to the indicated length.
26.
Where provided, the heat protection sleeve must be used over the full stripped length of the cable.
27.
The fitting is drip-proof.
28.
The fitting is rainwater-proof.
29.
The fitting is splash-proof.
30.
The fitting is dust-proof and splash-proof.
31.
The fitting is dust-proof and spray-proof.
32.
The fitting is dust-tight and splash-proof.
33.
Warranty Condition
The warranty period can be found on the pictogram on the front of the packaging.
If any damage was caused through incompetent use or modifications/repairs carried out by third
parties, then the warranty is no longer applicable. Normal wear and tear and consequential loss
are not included in the warranty.
