Multiva Optima T Series, Operation And Maintenance Manual, Page: 27 / 41

23
7. MAINTENANCE PROGRAMME, LUBRICATION
All lubrication points must be re-lubricated after the machine has been washed. DO NOT use a jet
cleaner to directly spray the labels or parts with bearings. Maintain a minimum distance of 30 cm
between the nozzle of the cleaner and the sprayed target.
Clean the lubrication nipples before lubrication. Wipe off excess lubricant. In all points, the lubricant
grease must be applied in the nipple until excess clean grease can be seen coming out of the target.
Some lubrication points only require a few drops -these are specified later on. The lubricant should be
general purpose grease that contains lithium soap and EP additives.
So called pin greases should never be used to lubricate the harrow. Using this type of grease may break
the bearings.
Table columns:
1 )
Daily
2 ) Every 500 ha or once in an operating period
1 ) 2 )
500 ha
Cage roller bearings X
Cage roller weighing adjustment threads X
Side section hinges X
Wheel hubs X
Mechanical depth adjustment threads, Optima T500 - T550 X
Towing eye X
Bogie bearings X
Middle axle X
Side section locking X
Side section hinges X
Levelling board adjustment threads X
Hydraulic cylinder spherical bearings X
Drawbar piston rod X
Selector valve spindles, Optima T500 - T700 X
Front support wheel adjustment threads, Optima 1000 - 1500 X