Multiva FX300 SeedPilot, Operation And Maintenance Manual

Page: 105 / 208

6.6.7. Adjusting the feeding quantity with the gearbox control lever
Figure. 6.6.7. - 123. Gearbox control levers
If the seed drill is equipped with a gearbox, the rough adjustment of the feeding
quantity is carried out by adjusting the roller width and the ne adjustment is carried
out from the machine transmission by adjusting the gearbox control lever. Control lever
(1) is for fertiliser and control lever (2) is for seed. The feeding quantity increases when
the value of the adjustment scale increases and vice versa.
Adjust the width of the feeder roller in accordance with section 6.6.5. Adjusting the
width of the feeder roller. When seeding grain and fertiliser, the rollers should be in
position 10. When seeding small seeds, the rollers should be in position 2.
6.6.8. Adjusting the bottom flap position
Figure. 6.6.8. - 124. Adjusting the bottom ap position
1. Change the position of the control lever (1) in the front of the seed drill on the notch scale
based on the material to be seeded.
Operation and maintenance manual
1.00 FX300 and FX400 SeedPilot
105 (208)